Claude review: arm64: dts: ti: k3-am62-verdin: Add Toradex Capacitive Touch Display 10.1" DSI

[Claude Code Review Bot <claude-review@example.com>]

Patch Review

This is a DSI display overlay using an SN65DSI83 bridge (note: SN65DSI**83**, single-channel LVDS, vs the SN65DSI**84** dual-channel in patch 1). The panel is a Riverdi RVT101HVLNWC00.

- The panel node uses `compatible = "riverdi,rvt101hvlnwc00", "panel-lvds"` with full `panel-timing` block. This is the correct pattern for `panel-lvds` compatible bindings — a vendor-specific first compatible string with `panel-lvds` as fallback, accompanied by explicit timing.

- Panel timing looks reasonable for a 1280x800@60Hz panel: `clock-frequency = <72400000>` (~72.4 MHz) with the specified blanking intervals yields approximately 60 Hz.

- The touchscreen uses `ilitek,ili2132` at address `0x41` with `IRQ_TYPE_EDGE_RISING` — this differs from patch 1's Atmel MaxTouch at `0x4a` with `IRQ_TYPE_EDGE_FALLING`. The different touch controllers and interrupt polarities match the different display products. Correct.

- This overlay and patch 6 (7" DSI) would conflict if both were applied simultaneously (same label names `backlight_pwm3`, `dsi_bridge_out`, `dsi_lvds_bridge_in`, `dsi_lvds_bridge_out`, `panel_lvds_bridge_in`). This is expected and fine — they're mutually exclusive overlays for the same DSI port.

- Composite DTB entries are added for both WiFi and non-WiFi Dahlia variants. Good.

**No blocking issues.**

---
Generated by Claude Code Patch Reviewer